HP Switches

Not every network upgrade needs brand new hardware. In a lot of cases, it’s more about replacing what’s outdated or adding capacity without overcomplicating things.

HP switches have been around for a long time, especially in office and campus environments. They’re generally straightforward to deploy, and once they’re in place, they tend to just run without much attention.

Netyorker focuses on refurbished units, which makes it easier to work within a budget while still using equipment that’s built for business use.

Why HP Switches Are Still in Use

Most teams using HP switches aren’t doing anything unusual. They need stable connectivity, predictable behaviour, and something that fits into the network without a lot of extra work.

That’s where these switches usually fit.

Across different models, you’ll typically see:

• standard Ethernet and Gigabit support, with 10GbE uplinks where needed
• PoE options for devices like access points and phones
• basic Layer 2 and Layer 3 features for segmentation and routing
• stacking on certain models to simplify management

Nothing exotic, but enough to handle day-to-day network requirements.

What Actually Matters in Practice

In most environments, it comes down to a few things.

PoE tends to be one of the more useful features. Being able to power access points, cameras, or phones directly from the switch avoids running extra power and keeps installations simpler.

Stacking is another one. Instead of managing switches individually, you can group them and treat them as a single system. That becomes useful once you have more than one switch in the same location.

Beyond that, it’s mostly standard switching — VLANs, routing, traffic handling — the things you expect to already be there.

Where Different Models Are Used

The models available usually depend on where they sit in the network.

Access Layer and PoE

At the edge, where users and devices connect, switches like the HP J9773A or ProCurve E3800 series are commonly used. They provide enough ports for office environments and support PoE for connected devices.

If there’s a need for higher port counts or additional uplink capacity, models like the J9625A are used to handle that.

Managed Fast Ethernet and Gigabit

In smaller setups or where cost is a factor, Fast Ethernet or basic Gigabit switches still show up.

The ProCurve J9089A, for example, is used in environments where full Gigabit across every port isn’t necessary. On the other hand, models like the J9729A provide standard Gigabit without additional features like PoE.

These tend to be used in simpler parts of the network where demand is lower.

Aggregation and Higher Bandwidth

Once traffic increases, higher-speed switches are needed further up the network.

Models like the JG896A or 5900 series are used in aggregation or core roles. They support higher bandwidth and are better suited for environments with heavier data movement.

This is where uplinks and throughput start to matter more than port count alone.

Refurbished Hardware — Why It’s Used

In most cases, the decision is practical.

Replacing switches across a network can get expensive quickly. Refurbished hardware gives you a way to upgrade or expand without replacing everything with new equipment.

As long as the units have been properly tested, they’ll perform the same role in the network.

It’s also useful when you’re trying to match existing hardware instead of introducing a different platform.

Netyorker

Netyorker supplies HP switches in refurbished condition, along with some new and open-box units.

For teams managing upgrades or replacements, having access to the same models without long delays makes planning easier. It also helps keep the network consistent instead of mixing different systems.